Vermont Casting 1655 - Manual (Page 12)

12
Madison Woodburning Stove
30001453
Madison 1655 Series Clearance Chart
Use the chart below together with the diagrams on the next page to determine the minimum clearance required for
your particular installation. In any case, it is always advisable to locate the stove as far away from walls as pos-
sible in order to take full advantage of the radiant properties of cast iron.
Stove clearances are measured between the cast iron Top Plate of the stove and the combustible surface. Note
that the cast iron back on the Madison protrudes 5” (127mm) out from the stovetop, and will therefore be closer to
the wall than the top of the stove.
Chimney Connector clearances are measured between the connector surface and the combustible surface. For
Douible-wall Chimney Connector, use the manufacturer’s listed clearance specification.
Use NFPA 211 default clearance or manufacturer’s installation specifications for those configurations not tested.
UNPROTECTED SURFACES PROTECTED SURFACES
Side Rear Corner Side Rear Corner
Top exit, no heat shields
Top exit, heat shields on stove,
no shields on single wall
connector
Top exit, heat shield on stove,
heat shield on single wall
connector
Top exit, heat shield on stove,
double wall chimney connector
Rear exit, no heat shields
Rear exit, heat shields
STOVE CLEARANCE
Without Connector Heat Shields
With Connector Heat Shields
CHIMNEY CONNECTOR
CLEARANCE
* A distance of 48" must be maintained between the stove and moveable combustible items such as drying
clothes, furniture, firewood, etc.
Corner
Installation
Parallel Installation
Corner
Installation
Parallel Installation
UNPROTECTED SURFACE / Vertical PROTECTED SURFACE / Vertical
FRONT CLEARANCE
TO COMBUSTIBLES* ALL INSTALLATIONS
48" (1220mm)
UNPROTECTED SURFACE / Horizontal PROTECTED SURFACE / Horizontal
Single-wall Connector
A 21”
(533mm)
B 24”
(610mm)
C 21”
(533mm)
M 21”
(533mm)
N 22”
(559mm)
O 18”
(457mm)
D 12”
(305mm)
E 14”
(356mm)
F 10”
(250mm)
19” (483mm) 13” (330mm)
23” (584mm) 23” (584mm)
G 21”
(533mm)
H 24”
(610mm)
I 21”
(533mm)
J 12”
(305mm)
K 14”
(356mm)
L 10”
(250mm)
P 12”
(305mm)
R 8”
(203mm)
Q 14”
(356mm)
T 12”
(305mm)
S 16”
(406mm)
W 11”
(279mm)
U 18”
(457mm)
N/A
N/A
X 8”
(203mm)
V 12”
(305mm)
Z 20”
(508mm)
Y 18”
(457mm)
BB 15”
(381mm)
AA 12”
(305mm)
N/A N/A
DD 18”
(457mm)
CC 16”
(406mm)
FF 12”
(305mm)
EE 12”
(305mm)