Cisco 12000 Series - Manual (Page 10)

5-10
Cisco 12000 Series Router SIP and SPA Hardware Installation Guide
Release 12.0(32)SY1, OL-8831-01, Rev. G6, July 19, 2007
Chapter 5 Installing and Removing a Shared Port Adapter
SPA Cable-Management Brackets
SPA Cable-Management Brackets
SPAs are shipped with an accessory kit that includes cable-management brackets. Figure 5-3 shows
cable-management brackets installed in a SPA, as well as cable routing.
Figure 5-3 SPA Cable-Management Brackets
To install cable-management brackets on a SPA, perform the following steps:
Step 1 Screw the two pull assemblies into both sides of the SPA.
Step 2 Insert the cable-management clip into the slot.
Step 3 To remove the cable-management clip, depress the button on the clip and pull it out.
Note Blank filler plugs are provided if no cable-management clips are installed.
FAN
STATUS
2
3
SUPERVISOR2
WS-X6K-SUP2-2GE
STATUS SYSTEMCONSOLEPWR MGMT RESET
CONSOLE
CONSOLE
PORT
MODE
PCMCIA EJECT
PORT 1 PORT 2
Switch Load 100%
1%
LINK LINK
STAT
US
2
0
3
1
MODULAR
SERVICES CARD
7600-MSC-600
OSM-4OC12 POS-SI
4 PORT OC-12 POS SM IR
STATUS
1
1
2
2
3
3
4
4
RESET
LINK LINK LINK LINK
CARRIER ALARM CARRIER ALARM CARRIER ALARM CARRIER ALARM
ACTIVE TX RX TX
PORT 1
RX
ACTIVE TX
RX TX
PORT 2
RX
ACTIVE TX
RX TX
PORT 3
RX
ACTIVE
TX
RX TX
PORT4
RX
129582
1
SPA-4XOC3-ATM
ST ATUS
0 C/A A/L 0 C/A A/L 0 C/A A/L 0 C/A A/L
ST ATUS