Cisco 12000 Series - Manual (Page 6)

5-6
Cisco 12000 Series Router SIP and SPA Hardware Installation Guide
Release 12.0(32)SY1, OL-8831-01, Rev. G6, July 19, 2007
Chapter 5 Installing and Removing a Shared Port Adapter
Checking the Installation
For more information about FPD upgrades, refer to the “Upgrading Field-Programmable
Devices” chapter of the Cisco 7600 Series Router SIP, SSC, and SPA Software Configuration Guide.
Step 5 Use the show version command to obtain a few details on the installed SIPs and interfaces available.
Using show Commands to Display SPA Information
Table 5-1 describes the show commands you can use to display SPA information.
Note A Fast Ethernet interface is used in the following examples for illustrative purposes.
The following sample display shows the events logged by the system as an SIP with a Fast Ethernet SPA
was removed from module slot 3; the system then reinitializes the remaining interface processors and
marks as down the Fast Ethernet interface on the SIP that was removed from slot 3.
Router#
18:04:29: %OIR-6-REMCARD: Card removed from slot 3, interfaces disabled
18:04:30: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet3/0, changed state
to down
Table 5-1 show Commands to Display SPA Information
Command Type of Information Provided
show running-config The router’s running configuration and interfaces available in the
system.
show hw-module subslot all oir The operational status of all SPAs in the system.
show diag SPA type in that slot, number of ports, hardware revision, part
number, and EEPROM contents.
show hw-module subslot all fpd FPD version information of SPAs in the system.
show version Cisco IOS software version, names and sources of configuration
files, and boot images.
Table 5-2 show Commands to Display SPA Information
Command Type of Information Provided Example
show controllers type
slot/subslot/port Network link status, register contents, and
controller chip errors. show controllers pos 2/3/0
show interfaces type
slot/subslot/port Line status and data link protocol status for a
particular SPA port. Statistics about data traffic
sent and received by the port. show interfaces pos 2/2/0
show diag slot SPA type in that slot, number of ports, hardware
revision, part number, and EEPROM contents. show diag 4
show version Cisco IOS software version, names and sources of
configuration files, and boot images. show version