Creda S930E - Manual (Page 8)

- 8 -
Technical information for the fitter
FRONT RIGHT MOUNTING
FRONT LEFT MOUNTING
SEAL MOUNTING
FRONT / REAR RIGHT / LEFT
MOUSSE 5x8 mm
HOB UNIT FAST DOWN
REAR RIGHT MOUNTING WORK
SURFACE
REAR SPRING ASSEMBLY
FRONT OF THE HOB UNIT
30
40
REAR LEFT MOUNTING
Electrical connection
• The electrical safety of this appliance can only be guaranteed if the latter is correctly and efficiently earthed, in
compliance with regulations on electrical safety. Always ensure that this vital safety measure has been taken. If you
have any doubts, call in a qualified technician to check the electrical system thoroughly.
•
The manufacturer denies all responsibility for damage resulting from a system which has not been earthed correctly.
• Before powering the appliance, check whether the technical characteristics featured on the appliance data plate
correspond with those of the mains electrical system.
•
Check that the current load of the mains supply and of the power sockets is suitable for the maximum power of the
appliance, indicated on the appliance data plate. If in doubt, contact a qualified professional.
Important notes
Your hob is delivered together with a specific SCHOLTES power supply cable. Should this cable be damaged, call your
nearest After-Sales Service Centre for its replacement.
Disconnect the appliance from the electricity supply before all operations.
You can connect your hob to the electrical system in two different ways:
1. use a socket conforming to the regulations in force in the country where the appliance is fitted and accessible
when necessary. Do not use adaptors or multiple sockets, nor extensions.
2. or by means of a junction box: if the appliance is connected permanently to the mains, an omnipolar circuit
breaker, accessible if necessary, with a minimum contact opening of 3 mm should be installed.