Clarion MAP670 - Manual (Page 56)

4.8.2 TMC control centre
This screen shows ce and allows you to change the TMC
settings.
the selected TMC sour
4.8.2.1 Selected FM radio station
any radio stations broadcasting TMC data in your area, the receiver
keeps on searching. You will see the frequency continuously sweeping across the
Hz). When you move to an area with TMC
4.8.2.2 Exclude selected station
rom another radio station, push this button. The
e / type
4.8.2.5 Use traffic information
to have Clarion ignore real-time traffic information
when planning routes.
a future journey, it may be better to turn off
The name and frequency of the selected radio station will appear at the top of this
window, together with signal strength information indicated by a bar similar to the
GPS satellite signal strength bars on the GPS Data screen.
If there aren’t
FM CCIR radio band (87.5-108 M
information, the indicator will show the frequency, and detailed information for the
TMC station.
If you wish to receive TMC data f
radio station will be added to the list of excluded stations, Clarion will start searching
for another TMC station, and will always skip the excluded station in the future.
4.8.2.3 Show excluded stations
This button opens the list of excluded radio stations. Tap any of the stations in the
list, then tap Enable to allow Clarion to accept TMC information from this station.
4.8.2.4 Sorts events by distanc
The list of traffic events can be ordered by their distance from the current position, or
by their type. Tap this button to toggle between the two possibilities.
This button is enabled by default, which means that TMC messages are used in
route planning. Tap this button
Tip: If you make a route planning for
TMC corrected route planning.
56