Cambridge SoundWorks MegaWorks THX 250D - Manual (Page 7)

7
Using the Wired Remote
To turn the system On/Off To turn the system On/Off Turning the system On/Off
❒ Ensure that the subwoofer’s
main power switch is On.
❒ Press the Standby/Power
Button once. The red indicator
above the button shuts off. The
Master Volume Mode
Indicator lights up.
❒ To switch the system to
Standby Mode, press the
Standby/ Power Button again.
❒ If the Master Volume Mode
Indicator is lit, press or
to vary the system volume.
❒ If the Master Volume Mode
Indicator is not lit, press the
Mode Select Button until the
Master Volume Mode Indicator
is lit. Then press or .
❒ To increase the rate of
adjustment, hold down or .
❒ Press the Mode Select Button
until the Sub or Treble Mode
Indicator is lit.
❒ To increase or reduce the Sub/
Treble level, press or .
❒ To increase the rate of adjust-
ment, hold down or .
❒ For private listening, you can
connect headphones to the
Headphones Output of the
wired remote. This will mute
all speakers.
❒ Adjust the headphones volume
as you would for the speakers.
❒ The Sub Mode can be used to
adjust the bass level you hear
from the headphones.
Fig 1: Wired
remote
Varying/muting the volume Adjusting Sub/Treble levels Using Headphones
Notes
• On first power-on, the system
uses a preset default master
volume level: two volume Level
Indicators will be lit.
• On subsequent power-on, the
system reinstates the last-used
master volume level.
• All volume and Sub/Treble set-
tings will be lost if you turn off
the main power switch, or remove
the AC power cord or wired re-
mote, or if there is a power inter-
ruption. The system will revert to
default master volume and Sub/
Treble levels.
Notes
• The remote will revert to Master
Volume Mode if left idle for some
time.
• To mute the master volume, press
the Mute Button once. The
system volume will be muted. All
previously-lit Level Indicators
will blink during the muting.
• To return to listening, press the
Mute Button again. Or press
or to return to normal listening.
• For your own safety, reduce the
master volume level before switch-
ing the system to Standby Mode.
Notes
• On first power-on, default Sub/
Treble levels (flat response) are
applied. Three Level Indicators
will be lit to reflect this. Pressing
boosts the level, and causes
more Level Indicators to be lit.
Pressing reduces the level, and
causes fewer Level Indicators to
be lit.
• Subsequent Sub/Treble settings
will be stored during Standby
Mode, and recalled when you next
turn the system on using the remote.
Notes
• Treble settings can be adjusted in
the same way as for the speakers.
• When you disconnect the
headphones, the system will revert
to a preset default master volume
setting (two Level Indicators lit),
in order to prevent high
headphones volume levels from
being applied to the system
speakers.