Disarming the system siren interrupt – Cobra Electronics 7928 User Manual

Page 5

Advertising
background image

Volumetric Protection

Exclusion

Illuminated Entry

Panic Alarm/

Personal Protection

period the system will close down and

automatically re-set to provide protection

against a further attempt by an intruder to

enter the vehicle.

On return to the vehicle, pressing

operating button ‘A' on the radio key will

disarm the system. This is indicated by:-
1. One flash of the hazard warning lights.
Note: If the system has been triggered

during your absence the hazard lights will

flash 4 times and the buzzer will sound 4

times.
2. Extinguishing of the LED warning light

- see note.

3. Unlocking of all doors.
Note: If the alarm has been triggered in

your absence a ‘status history' will be

displayed by the LED warning light and is

indicated as follows:-

Single pulse flashing of LED: One

alarm state caused by opening of the

boot, bonnet or doors.
Twin pulse flashing of LED: One

alarm state triggered by accessory

hyperfrequency radar sensors

(7928HF).
Triple pulse flashing of LED: Alarm

state triggered by the ultrasonic

sensor or optional glass break (7928).
Quadruple flash repeated regularly:

Alarm state caused by an attempt to

start the car.

Note: This display can also show multiple

triggering and other system diagnostics -

please consult your Cobra dealer in case of

any difficulties.
This display is extinguished when the

ignition is turned on.

Pressing button ‘A' whilst the siren is
sounding will turn the siren off. The Alarm
System ‘status' - i.e. ‘armed' - will not be
changed.

Pressing the auxiliary button ‘B' will sound
the siren for 10 seconds when the alarm
system is in the ‘armed' state.

Note: This function will not be operational
during the 40 seconds set-up time
required for the system to become fully
active after it has been ‘armed'.

Ultrasonic Sensor (7928):
To arm the system without utilising the
Ultrasonic interior sensor, press the
operating button ‘A' in the normal way
then, within 20 seconds, press the
auxiliary button ‘B'. This allows all other
protection circuits to remain active whilst
windows can be left partially open (for a
dog inside the vehicle etc.). This command
is indicated by a ‘beep' from the siren.

On disarm the system will switch ON the
courtesy light for 30 seconds, or until the
ignition is switched ON.

Disarming the System

Siren Interrupt

4

Advertising