Ocean Electronic Tabletop Heater - Manual (Page 7)

OWNER’S MANUAL
5
5-1. Fix 3pcs pins of 60mm
length to the emitter screen
with 3pcs M6 flange nuts then
tighten them.
6-1. Put the emitter screen on
the burner.
6-2. Use 4pcs 3/16” bolts to
connect the emitter screen to
the burner. Tighten the bolts.
7-1. Put the guard on the
burner through the emitter
screen.
7-2. Put the ends of the guard
into the holes of the burner.
8-1. Put 3pcs washers on each
pins of the 60mm length.
STEP 5 STEP 6
STEP 7
STEP 8