Contemporary Research ICC2-ATSC - Manual (Page 6)

Contemporary Research 6 ICC2-ATSC HDTV Tuner/Controller
Quick Setup Guide
Setup Step Options Notes
Front-Panel Programming
Tuning Mode
Baud Rate
Unit #
Zone #
Panel Lock
Power-Up Volume
IR Receive
Digital Audio
HD Out
HD Resolution
Hold and release Power and
Volume Up buttons
0.0 = Cable*
1.6 = 9600 baud
2.1 = Unit 1
3.1 = Zone 1 (See IC-Net Zones)
4.0 = Unlocked
5.0 = Restore to previous level
15.9 = On
47.2 = PCM Variable
48.0 = RGB
49.0 = 1080i
Channel Up/Down = Mode
Volume Up/Down = Options
Default Settings, change if
needed. See Front Panel for other
setting options.
Tip: Use Volume Down to access
list in reverse for HD and Audio
settings
On-Screen Menus
Channels
Time
Audio
Aspect Ratio
Use included HD2-RC Remote
Menu/Channel/AutoScan*
Signal
Menu/Channel/Add-Delete
Press List
Menu/Setup/Time
Menu/Setup/Audio/Digital
Menu/Setup/Screen Format
You can scan for Air and Cable
View channel signal strength
Add/Remove from Chan Up/Down
Add to Favorite channel list
Fine Tune and Noise Reduction
available for analog channels
Set DST and Time Zone
AC-3 (5.1, PCM, PCM Variable)
4:3 or 16:9, zoom options
(options vary when tuned to
analog and digital channels)
*You can initiate a channel scan without an IR remote (see next page for more options):
1. Put tuner into Front-panel programming mode (hold down Power, press Channel Up).
2. Go to Mode 0 and set Tuning Mode.
3. Go to Mode 6 using Volume Up button.
4. Press and hold Channel Up and Down, then press Power. This will exit programming mode and scan
channels.