Cables Unlimited SPK-24G - Manual (Page 4)

Remote Control
Installation
Transmitter
1.
Plug the included AC adapter into a standard wall outlet.
2.
Insert the adapter connector plug firmly into the DC IN jack located on the rear panel of the
transmitter base.
3.
Extend the retractable audio cable located on the back panel of the transmitter and connect it
to the output jack of virtually any audio source.
Note : Do not fully extend the cable until ready to retract.
4.
To retract the cable, pull it until it is fully extended and then allow it to feed back into the
base.
Speaker Receiver
Battery Power
1.
To operate the speaker using battery power, gently turn the speaker over and open the
battery compartment cover located underneath.
2.
Insert six (6) D alkaline batteries (not provided) into the battery compartment, observing
proper +/- polarities as indicated.
3.
Replace the battery compartment cover.