Crestron electronic CNRFGWA - Manual (Page 14)

Wireless RF Receiver Crestron CNRFGWA
10 • Wireless RF Receiver: CNRFGWA Operations Guide - DOC. 8086A
Uploading a SIMPL Windows Program
A control system source file has
the extension .smw. A compiled
SIMPL Windows file has the
extension .spz for a 2-Series
control system, .bin for CNX
generation, and .csz for CNX
generation with SIMPL+. The SIMPL Windows file can be uploaded to the control system using SIMPL
Windows or via the Crestron Viewport.
Upload via SIMPL Windows
1. Start SIMPL Windows.
2. Select File | Open to view the “Open” window, navigate to the
SIMPL Window file (.smw), and click Open.
3. Select Project | Transfer Program.
Upload via Crestron Viewport
1. Verify that the procedure for “Communication Settings” that begins on
page 8 has been performed.
2. As shown below, select File Transfer | Send Program (Alternatively,
press Alt+P) from the Viewport menu.
File transfer | Send Program Command
3. The “Send Program” window appears as shown after this step. Click
Browse, locate the completed file (.spz for PRO2) and click Open.
This displays the program’s header information and enables one or both
of the What to Send check boxes. If the program does not contain any
SIMPL+ modules, only the SIMPL Program check box is enabled. If it
does contain SIMPL+ modules, then the SIMPL+ Program(s) check
box will also be enabled. Select one or both check boxes and then click
Send Program to begin the transfer.
NOTE: Refer to the respective Operations Guide for control system details about the
other fields in the “Send Program” window.
“Send Program” Window