Canon BJ-230 - Manual (Page 83)

Miscellaneous Control Codes
BJ-10 Character Sets
In BJ-10 mode, your printer supports two IBM code pages: USA code
page 437 and Multilingual code page 850. Each code page has three
character sets: Character Set 1, Character Set 2, and All Characters
Chart.
You select the code page by setting DIP switch 9: OFF for code page
437, ON for 850. You select the character set by setting DIP swich 5:
OFF for Character Set 1, ON for Character Set 2.
Each code page corresponds to an All Characters Chart. For the All
Characters Chart, there are no control codes except for the space code
at ASCII 32. All other ASCII characters are printable. The All
Characters Chart is selected by the ESC ^ or the ESC \ code.
Character Set 1 has control codes in two places: one between ASCII 0
and ASCII 32 and the other between ASCII 128 adn ASCII 159.
Character Set 2 has control codes only between ASCII 0 and 32. All
other ASCII characters are printable.
The three character sets for each code page are shown on following
pages.
Function ASCII Decimal Hexadecimal
Select graphics mode (AGM) ESC * m n1
n2
27 42 m n1
n2 1B 2A m n1
n2
Set graphics line spacing (AGM); n =
0 to 255 ESC 3 n 27 51 n 1B 33 n
Set text line spacing (AGM); n = 1 to
85 ESC A n 27 65 n 1B 41 n
Perform graphics line spacing
(AGM); n = 0 to 255 ESC J n 27 74 n 1B 4A n
Function ASCII Decimal Hexadecimal
Set 360 dpi graphics FS C B 28 67 66 1C 43 42
Set/perform 1/360-inch graphics line
spacing FS C J n
m 28 67 74 n
m 1C 43 4A n
m
NOTE: A control code is an unprintable character that the printer
uses for printer operations, such as line spacing or carriage return.