Crane & Co. EE-5301(G) User Manual

Page 8

Advertising
background image

7

7.

The Indictor Light will turn on. In a few seconds mist will start emitting through the

openings at output slot.

8.

Use the control knob to adjust the intensity of the vapor

output. Turning the knob clockwise will increase the
moisture output, turning the knob counterclockwise will
reduce the moisture output (see Fig. 10).

Fig. 10

9.

When the humidifier runs out of water the humidifier will automatically shut off and

the mist will stop. This is a safety feature to prevent the humidifier from possibly
over heating and damaging the nebulizer. This safety feature uses a water level
sensor to stop the nebulizer once the water level sinks below the required level in
the water basin. Turn the humidifier off and unplug before removing and refilling the
water tank. Please note that the Indicator Light will stay on. The light indicates
that the humidifier is turned on and needs to be refilled.


SET THE CORRECT HUMIDITY OUTPUT


ALWAYS PLACE THE HUMIDIFIER ON AN ELEVATED NON-METALLIC, LINT
FREE, WATERPROOF, LEVEL SURFACE FOR BEST PERFORMANCE.

Adjust the vapor control so that the
vapor rises up and gets absorbed by the
room air. Do not turn on too high output
as the vapor cannot be absorbed by the
air and accumulates on the surface
around the humidifier.
If the humidifier is placed near a fan or
air conditioning outlet the vapor may be
forced down by the foreign air stream.
Change the location of the humidifier or
reduce the output of the other room
conditioning appliances.



correct

wrong

A NOTE ABOUT HUMIDITY

It is best to keep the humidity level at about 30-50 percent of relative humidity.

The comfort level of humidity will vary from room to room and with changing room

conditions.

In cold weather, windows and even some walls may fog or develop frost from

excessive indoor humidity. If this occurs, reduce the mist intensity setting to avoid
damage from condensed water dripping on windowsills.

Too much humidity in the room may allow moisture to accumulate on surfaces where

bacteria and fungi can grow. Moisture that gathers may also damage furniture and
walls, especially wallpaper.

To eliminate excessive humidity, especially in small rooms, leave the room door open

and adjust the mist intensity control setting.




Advertising
This manual is related to the following products: