CBC ZN-LN8048NHA - Manual (Page 14)

v2.0 - English
14
Unit Identification ó Time Server Settings
The camera can receive a time signal from an NTP server and use it to set the internal
clock. The device calls up the time signal automatically every two hours.
Time zone: select the current time zone.
Time server IP address: enter the IP address of the NTP server.
Display Settings
ó Camera name
Camera 1:
Enter here the camera name, click Set.
Display Settings ó Display stamping
You can configure the device so that the camera name, time and alarm source are
displayed on the video image. Select Top if the names are to be displayed at the top of the
image, or Bottom if the names are to be displayed at the bottom of the image. If you do not
wish the names to be displayed, select Off.
Camera name stamping:
Camera name is shown in the LH corner of the video image.
Time stamping:
Date and time are shown in the RH corner of the video image.
Alarm mode stamping:
Select On to display the alarm source (e.g. motion alarm) in the video image.
Select Off to not display the alarm source.
Displayed alarm message:
The text that should be displayed during an alarm event.