CBC ZN-LN8048NHA - Manual (Page 21)

v2.0 - English
21
The following events can activate the relay:
Ø Off: No relay triggering by events
Ø Connection: Triggering if any connection is established
Ø Video alarm: Triggering caused by loss of the video signal
Ø Motion alarm: Triggering by the motion alarm
Ø Local input: Triggering caused by an external alarm sensor
Ø Remote input: Triggering by a switching contact from a remote location.
Relay name:
The relay can be assigned a name here. The name will be shown on the live page,
depending upon the configuration.
Trigger relay:
Click on the button Relay to manually switch the relay (e.g. for test purposes or to
operate a door opener).
Service Settings ó Network Settings
Unit IP address: the unit’ s IP address.
Subnet mask: the unit’ s Subnet mask.
Gateway IP address: the gateway IP address (usually the router or firewall)
Video/Audio transmission:
If the device is used in front of a firewall, transmission over TCP (Port 80) should be
selected. If used in a local network select UDP.
Ethernet link type:
Adjust the type of Ethernet link to the network. In most applications, 'Auto' is the
correct choice.
For some routers and switches it may be necessary to set the
Ethernet link type to a fixed value.
Select the appropriate value:
10 MBit/s HD = 10 Mbps half-duplex
10 MBit/s FD = 10 Mbps full-duplex
100 MBit/s HD = 100 Mbps half-duplex
100 MBit/s FD = 100 Mbps full-duplex