CBC ZN-LN8048NHA - Manual (Page 9)

v2.0 - English
9
This camera is designed for indoor operations. Choose a site for installation
which ensures that the camera is NOT exposed to extreme temperatures or
extreme moisture or humidity.
The ambient temperature must be between
+40°F and 115°F (+5°C ~ 40°C) and the relative humidity cannot exceed 80%.
During operation, the unit generates a good amount of heat. Please ensure
sufficient ventilation and install this device away from heat-sensitive equipment
or objects.
Please observe the following installation conditions:
Ø Do not install the camera in the immediate vicinity of radiators or other sources of
heat. Avoid installing the camera where it is exposed to direct sunlight.
Ø Ensure sufficient space for laying the cables.
Ø Ensure adequate ventilation of the camera.
Ø For all cable connections, use cables which prevent electrical interference, where
necessary.
Ø Ensure that the camera is not exposed to water at the installation site. If necessary,
use fresh desiccant in waterproof housing to avoid moisture due to condensation.
Ø Lay and install all cables in such a way that they cannot be damaged and ensure
sufficient strain relief.
Ø The camera mounting position always depends on the actual situation. No concrete
instructions can be given here. The camera has a standard ¼”thread which can be
installed on both the top and bottom of the housing.
Ø Lay all cables up to the installation position.
Ø If necessary, connect a monitor with a coax cable to the BNC jack in order to be
able to check the video image on the spot (line impedance must be set by the switch
#8 to HIGH).
Ø Connect the leads of the power supply unit to terminals + and – of the DC 12V
CONNECTOR. Pay attention to the correct connection of the leads.
Network Connection
You can connect the camera via hub, switch or router to a 10/100 Base-T network. Use a
standard UTP Category 5 cable with RJ-45 connectors.
Alarm Inputs, Relay Output
The alarm inputs of the camera will allow you to connect to an external alarm trigger. If
configured accordingly, an alarm trigger can, for example, set up an automatic connection
between the camera and a remote station.
INSTALLATION