Chicago Electric SPOTLIGHT 30 MILLION CANDLEPOWER 93175 - Manual (Page 7)

SKU 93175 For technical questions, please call 1-800-444-3353 Page 7
5. Squeeze the open ends of the Light Bulb Clip (10) and remove it from the
Reflector. See photo below, left.
6. Carefully lift out the Light Bulb (1) assembly. See photo below, right.
7. Lift up on each wire connector tab and pull out the Light Bulb (1) connectors.
See photo below.
8. Discard the bad Light Bulb. Place the new Light Bulb near the work area.
Caution: Be careful not to touch the glass portion of the Light Bulb with the
hands. Any finger oil or debris on the bulb will cause it to explode when it gets
hot. If the new bulb is touched, clean with isopropyl alcohol and allow to dry
before installing. Hold the new Light Bulb assembly by its plastic base.
9. Push the new Light Bulb (1) connector wires onto the wire connectors coming
out of the Spotlight as shown above.
10. Insert the Light Bulb (1) into the Reflector and secure with the Light Bulb Clip
(10). Note that the base of the Light Bulb assembly has a slot and can only fit
into the Lens Reflector (5) one way. See photos at top of page.
11. Reassemble the Lens Rim to the Spotlight Body using the existing screws.
Securely tighten with the Spin Hand Wrench (not supplied). See photos at the
bottom of page 6.
12. Replace the Battery (2) as described on page 5.
Light Bulb Clip (10) Light Bulb (1) Assembly
Wire Connector Tab
Light Bulb (1)
Assembly
Lens Reflector (5)