Citizen Systems iDP-562 - Manual (Page 12)

iDP-562 User’s Manual
CITIZEN 7
4.3 Testing Your Printer
iDP-562 Model has a self-printing pattern in order to check the printing function.
Take the following procedures to test your printer.
1. Set the power switch.
2. Turn off the power switch.
3. Turn on the power switch while keep pressing the LF switch pressed down, then release the LF switch.
4. To stop the printing, turn off the power switch. After 9 lines are printed, the printing is stopped automatically.
•
And if turn on the power switch keep pressing both the SEL and LF switches, then the condition set by Dip
switch and Slide switch is printed and both SEL lamp and ALM lamp blinks. To stop the blinking, press the
either switch.
4.4 Cautions
1. Never operate your printer without loading paper and setting Ink Ribbon Cassette.
Any printing without paper and ink ribbon cassette may cause damage of printer head.
2. Replace the Cassette before ink ribbon is worn with rents.
3. Be careful not to drop any foreign matters, such as paper clips, pins and the like into your printer.
Those can cause mechanical trouble.
4. Nothing shall be placed on the radiation vents of the printer.
5. Place your printer always on a stable desk which is set horizontal.
6. No organic solvent (alcohol, thinner, benzine or the like) should be used in sweeping clean the surface of the
main body case.
7. Make sure that the power of the printer is turned off whenever you do the followings.
(1) Taking out any foreign matters which were dropped into the printer.
(2) Replacing the ink ribbon cassette.