Chauvet S-MOVER DMX512 - Manual (Page 7)

3. S
ETUP
Lamp
Optional 500W or 1000W lamps may be purchased from any Chauvet dealer.
Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the
unit to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
with alcohol and wipe it with a lint-free cloth before installation.
Lamp Installation
1) Remove the three thumbscrews
indicated in Figure A.
Figure A
2) Open lamp housing.
3) Remove socket from lamp.
4) Remove lamp from lamp housing.
5) Insert new lamp into lamp
housing.
6) Plug socket into lamp.
Note: you may need to bend the pins
of the lamp to close the housing!
7) Replace lamp housing cover and
tighten screws.
Fuse Replacement
Disconnect the power cord before replacing a fuse and always
replace with the same type fuse.
The fuse is located
inside this
compartment.
Remove using a flat
head screwdriver.
With a flat head screwdriver wedge the fuse
holder out of its housing. Remove the damaged
fuse from its holder and replace with exact
same type fuse. Insert the fuse holder back in
its place and reconnect power.
Stage Mover Manual 7 2007-04-13/09:39