CyberPower Systems CyberPower RMCARD201 - Manual (Page 6)

Cyber Power Network Management System
6
When the “SNMP Card Configuration Tool” program is unable to use, it can use the Command
Line tool instead of the “SNMP Card Configuration Tool” program to setup IP. Please follow the
steps listed below:
II. IP setup using Command Line command:
1.Obtain the MAC address on the label of the Network Management Card. (Each Network
Management Card has a unique MAC address).
2.To assign an IP address of 192.168.20.240 in the same subnet as your computer for a Network
Management Card, with a MAC address of 000c15000001:
Run an ARP command:
arp –s 192.168.20.240 000c15000001
and press Enter to set the IP address.
2. To verify the setting please try to ping the IP address you set:
ping 192.168.20.240
If reply is received, the IP address has been set.
To find an available unused IP address on your network for the Network Management Card, please
refer to Appendix 1.