Casio PX700 - Manual (Page 18)

E-16
Assembling the Stand
406A-E-018B
3 Attach the brackets I to the pedal unit F,
and temporarily secure them with the
screws G.
I
G
I
G
F
4 Remove the screws that hold the corner
brackets in place on the back corners (the
corners away from the pianist) of the side
panels.
5 Insert the plates on either end of the pedal
unit into the space between the corner
brackets and the edge of the side panels.
Protecting the Digital Piano against
Tipping Over
When locating the stand where it is not against a wall
creates the risk of it tipping over. To prevent this, orient
the corner brackets as shown below and insert the
pedal unit plates behind the corner brackets.
6 Secure the corner brackets to the stand
using the screws you removed in step 4.
Important!
When tightening the corner bracket screws, press
down on the pedal unit to ensure that the pedal
part comes into contact with the floor.
• The side panels have joint connectors inside that
engage with the corner bracket screws. If you
have trouble inserting the corner bracket
screws, use a screwdriver to adjust the position
of the joint connector as shown in the
illustration (
Ȣ).
7 Securely tighten the screws G that you
temporarily tightened in step 3.
8 Cover the screw heads with the screw caps
J.
J