Clarion DRX5675 - Manual (Page 9)

Setting the Z-enhancer
This unit comes with three types of sound tone
effects stored in memory. Select the one you prefer.
* The factory default setting is “Z-EHCR OFF”.
Each time you press Z-EHCR button ! , the
tone effect changes in the following order.
“Z-ENHANCER 1”
➜ “Z-ENHANCER 2” ➜
“Z-ENHANCER 3” ➜ “Z-EHCR OFF” ➜
“Z-ENHANCER 1”...
• Z-ENHANCER 1: bass emphasized
• Z-ENHANCER 2: treble emphasized
• Z-ENHANCER 3: bass and treble emphasized
• Z-EHCR OFF: no sound effect
Loudness Effect
In order to turn on/off the loudness effect, use
the LD button
2 for 2 seconds or longer. Every
time the LD button 2 is pressed and held for 2
seconds or longer, the loudness effect switches
on and off.
* When the loudness effect is on, the display will show
“LD”.
Switching the Clock Display
Every time the DISP button 5 is pressed, the
display will change between the operation mode
and the clock display.
Setting the Clock
1) Press the DISP button 5 to display the clock
display.
2) Press and hold the DISP button 5 for 2 sec-
onds or longer.
3) Press the SRCH Left button # , then set the
current hour.
4) Press the SRCH Right button # , then set the
current minute.
5) Press the DISP button 5 , then the clock is
set.
Notes:
• If you select another operation mode while you are
setting the clock, the clock setting operation will be
canceled.
• If you remove the vehicle’s battery for a check or
repair, the clock will be reset, so you must set it again.
Radio Mode Operations
FM Reception
For enhanced FM performance the ®
tuner includes signal actuated stereo control and
Multipath noise reduction circuits.
Listening to the Radio
1) Press the FNC button 3 to select the radio
mode, then the radio will be on.
2) To select a preset band, press the BND but-
ton @ , then select one of the preset bands
such as FM1, FM2, FM3, or AM. Every time
the BND button
@ is pressed, the display will
change as:
FM1
➜ FM2 ➜ FM3 ➜ AM ➜ FM1
3) Press the SRCH Left/Right button # , then
the station at which there is a broadcast will
be selected (Seek selection).
Mute
Use this function to turn off the sound immedi-
ately.
Press the MUTE button
% . The sound turns off
and “MUTE” appears on the display. Press the
MUTE button again to cancel the mute mode.
Manual Tuning
1) Press the BND button @ , then select FM1,
FM2, FM3 or AM.
2) Press and hold the BND button @ for 2 sec-
onds or longer, then the display will show
“MANU”, which means that a manual selec-
tion function is on.
3) Press the SRCH Left/Right button # and
select the right station.
Seek Tuning
1) Press the BND button @ , then select FM1,
FM2, FM3 or AM.
2) If the “MANU” on the display is on, press and
hold the BND button @ for 2 seconds or
longer. When the “MANU” display is off, the
Seek Selection function is on.
3) Press the SRCH Left/Right button # , then
when it selects the station in which there is a
broadcast, it automatically stops.
DRX5675
11
English