Casio DT-800RF - Manual (Page 26)

Terminal Setup
Printer Type
This scrolling list selects the attached printer type. The default value is none , indicating
no printer is attached.
Terminal Setup Using Twin Client Menus
The Twin Client terminal software provides an internal menu system for configuring
certain parameters on the terminal and for switching between “server” and “telnet” mode
of operation. To access this menu system, press the uppercase
C at the startup screen as
shown in the following figure.
Twin Client
© 1991-2006, Connect, Inc.
Keypress to Continue
The next screen displays the menu options. Cursor to the appropriate option and press
Enter .
Edit Menu Options
Edit Mobile Unit IP
Edit Server/Host IPs
Edit License Key
Run Site Survey
Switch Client Modes
Run Client Emulator
Exit to OS
Use the Up-Arrow and Down-Arrow keys to navigate the menu, and press Enter to select
the highlighted option. Each menu option is described below.
Edit Mobile Unit IP
The IP list contains the terminal IP address, the Subnet mask, and the Router IP address.
Enter the appropriate address and select
F3 to save and/or F7 to quit.
IP 206.232.71.38
SN 255.255.255.0
RT 206.232.71.1
<F3> Save <F7> Quit
Press F3 to save the configurations.
Edit Server/Host IPs
If you wish to change the host IP address or addresses using the terminal menus, select
this option and enter up to four Host IP addresses as required.
Supported Equipment Manual
• March, 2006 2-18