Clarion CJ7100E - Manual (Page 2)

Protect your investment with advanced in-car
surveillance equipment from the world’s leading
provider of automotive media systems
Our state-of-the-art computer design system simulates various climatic conditions and every product goes through a
wide range of quality control tests. Only when products pass these tests, are they entitled to bear the Clarion insignia
and be delivered to our customers around the world. And thanks to advanced automation, our factories produce
50,000 in-vehicle CCD cameras for both commercial and private vehicles in countries around the world each and
every month. So when it comes to in-car surveillance — leave it to Clarion. Because if it’s “in-car,” it’s Clarion.
As a world leader in the development and production of in-car media equipment,
Clarion has always been at the forefront of technological evolution. Our years of
experience — including more than four decades of development of in-vehicle camera
systems — have given us an expertise that none can match. And nowhere is that
expertise more important than in designing safety camera and monitor systems.
Our reliability is backed up by one of the world’s most rigorous production line quality
assurance systems because we know that our in-vehicle equipment must perform
consistently and reliably no matter where it’s being used — whether it’s the hot
tropics, a parched desert, a wet rainforest, or the freezing cold of the far north.
Headquarters and Technical center
building
Waterproof test
Assuming vehicles are washed
by a car wash and exposed to
the weather, we check for water
penetration inside the camera
and determine how watertight
the equipment is.
Temperature test
Reliability under rapid
temperature change is checked,
including performance
confirmation under high and low
temperatures.
Vibration test
Assuming our products are
used in commercial vehicles, we
confirm durability by subjecting
them to severe vibrations.
Repetition durability test (to check camera’s shutter
release and monitor’s controls)
We check the durability of movable parts such as shutter
opening/closing and monitor controls by conducting more than
50,000 operation tests.
2 3