Cooper Lighting ADY080864 - Manual

Canopy
Appropriate fasteners
(by others)
(x2)
Mounting plate
1. To mount non-power side pendant, use dimensions provided
on page three(3).
2. Using appropriate fasteners(by others), secure mounting plate
to structure/ bracing in ceiling.
End cap
#8-32 x.75"
Cap screw
(x2)
1/4-20 x1"
Aiming screw
3/8-16 x1"
Hex end screw
(x2)
Fixture door
Mounting bracket
Canopy
Exploded View and Part Call-Out
J-box
(by others)
Securing Power side Pendant to Ceiling
Attention:
All extra large fixtures require additional bracing/structure around J-box to support fixture.
Securing non-Power side Pendant
Pendant length dependant
on order(multiple sections
may be required, consult
factory for coupler and
safety wire installation
requirements).
Appropriate fasteners
(by others)
(x2)
Canopy
J-box
(by others)
Mounting plate
1. Remove canopy and allow it slide down pendant.
2. Using appropriate fasteners(by others), secure mounting
plate to structure/ bracing around J-box.
3. For mounting plate dimensions refer to page three(3).
Warning : Before starting any work ensure
that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician. Do not
mount fixtures vertically.
Installation Instructions
1.
Sheet 1 of 3
Roundel, XL
INDOOR
PS
(Pendant Swivel)
Visor and Non-Visor
2.
ADY080864 REV B(ECN080377)