Chauvet DMX-250C - Manual (Page 3)

DMX-250C User Manual 3 Revision: 5/17/2005 10:49 PM
B
EFORE
Y
OU
B
EGIN
What is included

Omega
™
250C (DMX-250C)

Power cord with plug

ELC 24V 250W MR-16 lamp

Diffusion filter an O-ring locking attachment (Installed)

Manual with Warranty Card
Unpacking Instructions
Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that
all parts are present, and have been received in good condition. Notify the shipper immediately and
retain packing material for inspection if any parts appear damaged from shipping or the carton itself
shows signs of mishandling. Save the carton and all packing materials. In the event that a fixture
must be returned to the factory, it is important that the fixture be returned in the original factory box
and packing.
AC Power
To determine the power requirements for a particular fixture, see the label affixed to the back plate of
the fixture or refer to the fixture
’s specifications chart. A fixture’s listed current rating is its average
current draw under normal conditions. All fixtures must be powered directly off a switched circuit and
cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel is used solely for a 0% to 100% switch. Before
applying power to a fixture, check that the source voltage matches the
fixture
’s requirement. Check the fix
ture or device carefully to make sure that
if a voltage selection switch exists that it is set to the correct line voltage
you will use.
Warning! Verify that the power select switch on your unit matches the line voltage applied. All
fixtures must be connected to circuits with a suitable Earth Ground.
Safety Instructions
 Please keep this User Guide for future consultation. If you
sell the unit to another user, be sure that they also receive
this instruction booklet.

Always make sure that you are connecting to the proper
voltage and that the line voltage you are connecting to is
not higher than that stated on decal or rear panel of the
fixture.

This product is intended for indoor use only!

To prevent risk of fire or shock, do not expose fixture to
rain or moisture. Make sure there are no flammable
materials close to the unit while operating.
 The unit must be installed in a location with adequate
ventilation, at least 50cm from adjacent surfaces. Be sure
that no ventilation slots are blocked.
 Always disconnect from power source before servicing or
replacing lamp or fuse and be sure to replace with same
lamp source.
 Secure fixture to fastening device using a safety chain.
Never carry the fixture solely by its head. Use its carrying
handles.
 Maximum ambient temperature is Ta: 40 ° . Do not operate
fixture at temperatures higher than this.

In the event of serious operating problem, stop using the
unit immediately. Never try to repair the unit by yourself.
Repairs carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest
authorized technical assistance center. Always use the
same type spare parts.

Don
’t connect the device to a dimmer pack.
 Make sure power cord is never crimped or damaged.
 Never disconnect power cord by pulling or tugging on the
cord.
 Avoid direct eye exposure to lamp while it is on.
Caution! There are no user serviceable parts inside the unit. Do not open the housing or
attempt any repairs yourself. In the unlikely event your unit may require service,
please contact CHAUVET.
Figure 1 - AC Voltage Switch
Please read these instructions carefully, which includes important
information about the installation, usage and maintenance?