Coleman 9993 Series - Manual (Page 10)

Grill Assembly
(continued)
10
5. Install one washer and a
hairpin cotter on each pin
(Fig. 26).
Fig. 26
Fig. 28 Fig. 29
Fig. 27
1. Insert the ends of the Propane Tank Retainer into the holes provided in
the right side panel (Fig. 30).
Fig. 30
1. Insert the ends of the Wire
Shelf into the holes provided in
the left side
panel (Fig. 31).
Fig. 31
2. Use a screwdriver to loosen
the brackets (Fig. 32).
Place the wire under the
two brackets and retighten
the screws.
Fig. 32
1. Install both doors by first
inserting the lower pin in the
hinge hole (Fig. 33). Then
depress the upper retractable
pin and allow it to snap into the
upper hinge hole. NOTE: if
the doors need vertical
alignment, place one or more
washers (provided) on the
lowest post.
Fig. 33
2. Assemble the Tool Hook to
the left door using three
screws. Tighten the screws
with a screwdriver (Fig. 34).
Fig. 34
Assemble the Doors and the Tool Hook
Assemble the Wire Shelf
Assemble the Propane Tank Retainer
Assemble the Warming Rack
and the Grease Tray
Assemble the Grill Lid
(continued)