Chief Manufacturing PL-4 User Manual
Rpa series projector lock (pl-4), Installation, Parts list
Chief Manufacturing, a division of Milestone AV Technologies
8803-000039 Rev. C
8401 Eagle Creek Parkway
©2008 Milestone AV Technologies
Savage, MN 55378 USA
P: 800.582.6480 / 952.894.6280 F: 877.894.6918 / 952.894.6918
10/08
I N S T A L L A T I O N I N S T R U C T I O N S
RPA SERIES PROJECTOR LOCK
(PL-4)
The PL-4 Projector Lock is designed to provide security
for your LCD/DLP Projector when it is attached to the
RPA series ceiling mount.
INSTALLATION
1. Two methods of installation are possible:
a.
Run steel cable through projector handle and
then through RPA series ceiling mount.
b. Before attaching adhesive plate, clean area on
projector with alcohol wipe. Attach the adhesive
retainer plate to exterior chassis of the projector.
NOTE: Adhesive will secure retainer in plate to
projector and become fixed. For maximum
adhesive strength, adhere retainer plate to
projector and do not attempt to remove the
cable lock right away. Allow the adhesive to
become stronger and cure over time.
2. Securely lock cable to cylinder lock.
3. Retain keys.
PARTS LIST
Unpack the shipping carton and check for the contents
listed in Table 1.
Table 1. Parts List
REF
DESCRIPTION
QTY
10
ADHESIVE
RETAINER
PLATE
1
20
CABLE
LOCK
ASSEMBLY
1
30 KEYS
2
40 ALCOHOL
WIPE
1
Lock
Assembly
RPA
SLB- Hanging
Bracket
Clip Retainer with
Adhesive Backing.
Adhere to Projector.
Projector