Philips 30PW8502-37 - Manual (Page 31)

S etting the R emote C ontrol to O perate A ccessory D evices
C ode E ntry M ethod
' I 'he remote control supplied with your TV can
J. also be programmed by entering a specific code
for your type of accessory device. Follow the
instructions below to program the remote using one
of the codes listed on pages 32-34.
Look up the codes for your brand of acces-
I sory device.
Once you have the codes, simultaneously
press the SELECT and OK buttons.
Press the NUMBER button that corresponds
to the type of accessory device you are using.
Digit 1 = Cable
Digit 2 = VCR
Digit 3 = DVD
Digit 4 = SAT
Digit 5 = AMP
^ Press the NUMBERED button to enter the
4 digit code number from pages 32-34.
Be sure the remote is in the correct MODE
(see previous page) and press the POWER
button. If the accessory device powers ON
your finished. If it does not power ON, repeat
the procedure with another code listed. If aU
codes faU, the remote will not control your
specific accessory device.
(Example: You have a Cable Box from Archer and
want to program the remote. It’s code is 0049. Press
the SELECT and STANDBY button simultaneously.
Press the NUMBER 1 for Cable, then enter the list­
ed four digit code; i.e.; 1,0,0, 4, 9.)
llEi.ri I I. H im
It is recommended that you use Philips
brand external accessory devices with your
Philips television to insure proper remote
control functions. If you are using Philips
brand accessory devices, your remote con­
trol should be ready to use with these
devices.
Codes from
page 32-34
VCR
SateUite Receiver
Cable Converter
31