Can-Am BOMBARDIER DS650 - Manual (Page 120)

BODY/FRAME
Engine Area
Check engine area for any damage
and leaks.
Ensure all hose clamps
are properly secured and no hose is
cracked, kinked or otherwise dam-
aged.
Inspect muffler, battery and
reservoir fastening devices. Check
electrical connections for corrosion
and tightness. Replace or have dam-
aged parts repaired.
Skid Plate
Check tightness of fasteners and
condition of plate for cracks or other
damage. Properly retighten fasteners
as necessary and have skid plate re-
placed if damaged.
Front Fenders
Check tightness of fasteners and con-
dition of front fender for cracks or oth-
er damage. Properly retighten fasten-
ers as necessary and have front fender
replaced if damaged.
ƽ
WARNING
Never remove the front fenders.
The important labels are applied
on the front fenders.
Operating
without front fender, increases
your chances of severe injury in
the event of an accident.
Fasteners
Check fastener condition and tight-
ness on the vehicle.
Retighten as
required.
Seat Latch
Remove seat and check latch mecha-
nism and pin for wear. See an autho-
rized Bombardier ATV dealer for parts
replacement if damaged.
Frame
Check frame for cracks or other dam-
age. See an authorized Bombardier
ATV dealer for replace or repair.
Vehicle Cleaning and
Protection
Painted parts which are damaged
should be properly repainted to pre-
vent rust.
When required, wash the body with
hot water and soap (only use mild de-
tergent). Apply non-abrasive wax.
CAUTION: Never clean plastic parts
with strong detergent, degreasing
agent, paint thinner, acetone, etc.
NOTE: Never use a high pressure
washer to clean the vehicle USE
LOW PRESSURE ONLY (like a gar-
den hose). The high pressure can
cause electrical or mechanical dam-
ages.
While reading this Operator’s Guide, remember that:
ƽ
WARNING
Indicates a potential hazard that, if not avoided, could result in serious in-
jury or death.
118
_____________________