Century SMART MOVE PM-1634AB 6/01 - Manual (Page 14)

OPERATIONS and ADJUSTMENTS
Recline / Upright Positions:
Rear-facing - MUST use Reclined (#1) or
Semi-reclined (#2) position.
Forward-facing - MUST use Semi-upright (#3)
or Upright (#4) position.
• Squeeze lever located under front (fig. b)
or rear (fig. c) of car seat.
• Move car seat to desired position by
aligning pointer to desired position.
Be sure car seat locks into position.
Harness straps MUST move freely. Make sure
harness straps are not pinched between lever
and car seat shell.
Harness Straps (fig. a):
• To tighten: Pull lower belt tab.
• To loosen: Pull and hold upper belt tab
while pulling harness straps out.
Harness Tie:
• To open: Press tab and pull apart.
• To close: Snap halves together. Make
sure harness tie is locked by pulling out
on each half.
Buckle:
• To buckle: Insert both tongues into
buckle. Pull up on tongues to be sure
they are locked.
• To unbuckle: Press red button and pull
tongues out of buckle.
1
2
4
3
12