Scanning, P. 33 – Canon D646U User Manual
Page 33
Advertising
33
S T E P 2
Scanning
Once you have set the magnification and scan mode, you may proceed with the
scan. Once the scan is complete, Plug-in Module CS-U automatically closes and
returns to the application software, such as CanoScan Toolbox or ArcSoft
PhotoStudio 2000. The following provides an example of scanning from within
ArcSoft PhotoStudio 2000.
To Initiate the Scan
Specify the Scan Area.
Click on the [Scan] button.
• The scan will start.
• Plug-in Module CS-U will automatically quit when the scan finishes.
Hint
• The scan button cannot be clicked if the scan area is set too small (less
than 64x64 pixels) or not specified.
• The scan cannot be performed if the required memory is larger than the
free disk space.
➟
Advertising