Crimestopper Security Products SV-6400 - Manual (Page 5)

Page 5 of 8
6. Optional installation: Sometimes the space between vehicle license plate
and rear trunk lip area is very narrow, which may cause problems when
installing the ClipCam. An adjustable bracket is available to deal with this
problem. Install the adjustable bracket to move up the license plate until
you have enough space to install the ClipCam.
Step 4: Wire Connection
1. Connect the power source line to the camera. Also connect a 20’ cable with
monitor. (Refer to Diagram 4.1)
4 pin connector
Pin No. PART-DESC
1 Video Output
2 Power DC 12V
3 GND
4
Video output to monitor
2
1
4 3
Diagram 4.1-1
Diagram 4.1-2
Clip Cam
Black, Ground
Red, power input 12V (+) from reverse light
12 PIN (M)
12 PIN (F)
4 PIN (M)
4 PIN (F)
RED Power Input 12V(+)
BLACK Power Input 12(-)
Waterproof Camera
Connector
Video Output
Standard Cable Connector