G-Shock QW-1825 - Manual (Page 2)

— 5 —
To set the alarm time
1. Hold down A until the hour setting starts to flash on the display. The hour setting
flashes because it is selected.
• This operation automatically turns on the Daily Alarm.
2. Press
C to change the selection in the following sequence.
3. While the hour or minutes setting is selected (flashing) press E to increase it or B
to decrease it. Holding down either button changes the current setting at high
speed.
• The format (12-hour and 24-hour) of the alarm time matches the format you select
for normal timekeeping.
• When setting the alarm time using the 12-hour format, take care to set the time
correctly as morning (no indicator) or afternoon (P).
4. After you set the alarm time, press A to return to the Alarm Mode.
• If you do not operate any button for a few minutes while a setting is flashing, the
flashing stops and the watch goes back to the Alarm Mode automatically.
To turn the daily alarm and hourly time signal on and off
Press B while in the Alarm Mode to change the status of the daily alarm and hourly
time signal in the following sequence.
• The alarm on indicator (ALM) and the Hourly Signal on indicator (SIG) are shown on
the display in all modes while these functions are turned on.
To test the alarm sound
Hold down E while in the Alarm Mode to sound the alarm.
Hour Minutes
Hourly Time
Signal Only
SIG ALM SIG
Both ON Both OFF Daily Alarm
Only
ALM