Verykool i315N - Manual (Page 12)

2.3.1 Battery charging
Ø Plug the charger.
Ø Plug the charger connector into the bottom of the phone, "charging / data transfer
interface."
Ø At this time, the screen upper right corner of the charge level indicator will flash
in cycle: If the charge is turned off, charging indicator will appear on the screen,
which means the battery is charging. If the phone is still excessive used when the
power is low, the charging indicator may take some time after the start to appear
on the screen.
Ø When the indicator in the upper right corner of the screen indicator shows full
and no longer flashes, it means that the charge has been completed. This process
usually takes 3 to 4 hours. During charging, batteries, cell phone and charger may
become hot, which is normal.
Ø After charging, disconnect the AC power outlet with phone and charger.
Ø Note:
——It must be placed in temperature +5 0 C～+40 0 C for ventilation while charging and
be sure to use the charger provided by the manufacturer. Using an unapproved charger
may be dangerous and it violate the recognition of the mobile phone and warranty.
——
When the phone is automatically shut down or show low battery warning
"battery low", it is timely to charge the battery. If you do not run out it before
charging the battery, the phone will automatically reduce the charging time.
——The standby and talk time provide by Mobile phone manufacturers are based on
the ideal working environment. In actual use, the battery working time may be
changed as the network status, work environment and the way of use.
12