Amaze, Drain installation, Drain – Produits Neptune AMAZE rectangle User Manual
Page 5
amaZe insTallaTion guide
5
0 3 - 2 0 1 2
AMAZE
Drain
1 - Overflow face plate
2a - Overflow bolt
2b - Overflow tie plate
3 - Overflow gaskets
4 - Overflow elbow (assembly)
5 - Rubber collar
6a - 1 ½ " brass tailpiece
6b - Tailpiece nut
6c - Washer
7 - Waste elbow (assembly)
8 - Waste washer
9 - Putty ring
10 - Strainer
11 - Plug lifting assembly
12a - Plug
12b - Plug gasket
ASSEMBLY INSTRUCTIONS
The corrugated brass tube can be easily bent to match any tub slope. To bend to the desired angle, keep your hands
approximately 6" apart applying constant and even pressure. The tube should not kink if care is taken. If the overflow
tubing is too long, cut it so that the waste elbow (7) and the overflow elbow (4) can fit in the holes of the bathtub.
Place the drain on the bathub, temporarily tighten the different parts, taking care not to damage the gaskets,
then proceed with the installation steps of the bathtub.
The seals (3 & 9) might not be sufficient for certain bathtub models. In that case, make sure to apply additional silicone
before the final installation. Make sure to tighten all parts properly to prevent leakage or breakage.
4
5
1
2a
2b
3
9
10
8
7
6c
6b
6a
11
12b
12a
drain
installation