Crimestopper Security Products CS-870RKE - Manual (Page 14)

14
TRANSMITTER PROGRAMMING
1. Turn Ignition ON.
2. Press the Program/Override Button 4 times. After a few second delay, the unit will chirp and flash the
lights 4 times.
3. Press button 1 on the remote control you wish to learn. You will get 2 Horn chirps and light flashes
indicating the unit is waiting for a 2
nd
code, then press button #1 of a second transmitter or transceiver,
the unit will chirp and flash the lights 3 times indicating its waiting for the 3
rd
code and 4 times. If all 3
codes are learned, the unit will automatically exit code-learning mode, otherwise turn key off to exit
programming mode.
Note 1: All transmitter codes must be learned at the time of programming. Any transmitters not present will
be dropped from system memory. This system will learn a total of 3 transmitters max.
IGN
OFF
WAIT FOR
4 FLASHES
PRESS PROGRAM
FLASH 2, 3, or 4 X's
IGN
OFF
PRESS BUTTON #1
TURN IGN ON
4 TIMES
ON EACH REMOTE
ANIC