Keri Systems EP2500 - Manual (Page 5)

Mercury Security Corporation, Copyright 2011 EP2500 DOC 10107-0030 REV: 1.03 Page 5
Information subject to change without notice.
Warranty
Mercury Security Corporation warrants the product is free from defects in material and workmanship under normal use and service with proper
maintenance for one year from the date of factory shipment. Mercury Security Corporation assumes no responsibility for products damaged by
improper handling or installation. This warranty is limited to the repair or replacement of the defective unit.
There are no expressed warranties other than set forth herein. Mercury Security Corporation does not make, nor intends, nor does it authorize
any agent or representative to make any other warranties, or implied warranties, and expressly excludes and disclaims all implied warranties of
merchantability or fitness for a particular purpose.
Returned units are repaired or replaced from a stock of reconditioned units. Returns must be accompanied by a return authorization number (RMA)
obtained from customer service, and prepaid postage and insurance.
Liability
The Interface should only be used to control exits from areas where an alternative method for exit is available. This product is not intended for,
nor is rated for operation in life-critical control applications. Mercury Security Corporation is not liable under any circumstances for loss or damage
caused by or partially caused by the misapplication or malfunction of the product. Mercury Security Corporation's liability does not extend beyond
the purchase price of the product.
Cable requirements:
Power: 1 twisted pair, 18 AWG
RS-485: 24 AWG, 4,000ft (1,200m) maximum, twisted pair with shield. 120 Ohm
RS-232: 24 AWG, 25ft (7.6m) maximum
Ethernet: Cat 5
Alarm input: 1 twisted pair, 30 ohms maximum
Environmental:
Temperature: 0 to 70°C, operating
-55 to +85°C, storage
Humidity: 0 to 95% RHNC
Mechanical:
Dimension: 5 in. (127mm) W x 6 in. (152.4mm) L x 1 in. (25mm) H
Weight: 4.1 oz ( 115 gm) nominal
Lantronix NIC support: Standoff size - Diameter .125 inch x 7/16 inch long
Richco, Inc. part number LMSP-7-01, 3 pieces (Not supplied)
Specification subject to change without notice.