KERN & SOHN TC 1250-0.1 FN - Manual

Sauter GmbH
Ziegelei 1
D-72336 Balingen
E-Mail: [email protected] Tel: +49-[0]7433- 9933-199
Fax: +49-[0]7433-9933-149
Internet: www.kern-sohn.com
Instruction Manual
TC
TC-BA-e-1310 1
Digital coating thickness gauge
Model: TC 1250-0.1 F
TC 1250-0.1 N
TC 1250-0.1 FN
Table of contents
Features
Specifications
Front panel description
Measuring procedure
Calibration
Battery replacement
Trouble shooting
Restore factory settings
Notes
Declaration of conformity
Annotation: It is strongly recommended to calibrate
the new instrument before the first use, as
described in paragraph 5. By doing this it
will be achieved a much better measure-
ment result right from the start.
1. Features
* This instrument meets the standards of both, ISO 2360
and DIN as well as ASTM and BS.
It is suitable for the laboratory and for use in `harsh field`
conditions.
* The N- mode measures the thickness of nonmagnetic
coatings, e.g. anodizing, varnish, paint, enamel, plastic
coatings, powder etc. These layers are located on non-
magnetic metals e.g. aluminium, brass, nonmagnetic
stainless steel etc.
* Automatic substrate recognition
* Manual or automatically “auto power off” to conserve
batteries.
* Two measurement modes: - single and continuous
* Wide measuring range and high resolution
* Date transfer to PC possible
2. Specifications
Display: 4 digits
Range: 0 to 1250 µm/ 0 to 50 mil
(another range may be specified)
Resolution: 0.1 µm (0 to 100 µm)
1 µm (over 100 µm)
Accuracy:
- Standard: 3% of the measured value or min. ± 2.5 µm
Is valid within a tolerance range of ± 100
μm around the
individually measured range, if a two-point calibration was
performed within this tolerance range.
- Off-Set Accur Mode: 1% of the measured value
or min. ± 1.0 µm
Is valid within ± 50
μm around the Off-Set Accur point.
PC- interface: with RS-232C interface
Power supply: 4x 1.5V AAA (UM-4)
Operating conditions:
Temperature: 0 to 50°C
Humidity: < 80%
Size: 126 x 65 x 27 mm (5.0 x 2.6 x 1.1 inch)
Weight: about 81g (not including batteries)
Accessories: carrying case
- Operation manual
According to Models:
1.incorporate F sensor at model TC1250-0.1F
with button F/N
2. incorporate N-sensor at model
TC1250-0.1N with button F/N
3. incorporate FN-sensor at model
TC1250-0.1 FN, Without button F/N and S/C
- Calibration foils (at each model)
- Base plate (aluminium) at model N
- Base plate (iron) at model F
- 2 Base plates (iron and aluminium) for
Model FN, the combination model
Optional accessories: Cable & software for RS-232C
3. Front panel description
Model TC F and TC N Model TC FN
3-1 Sensor: F, N or FN
3-2 Display
3-3 Zero- key
3-4 Plus- key