KERN & SOHN TVM - Manual

Sauter GmbH
Tieringerstr. 11-15
D-72336 Balingen
E-Mail: [email protected] Tel: +49-[0]7433- 9976-174
Fax: +49-[0]7433-9976-285
Internet: www. sauter.eu
Instruction Manual
TVM
TVM-BA-e-1112 1
Thank you for buying a SAUTER test stand. We hope you
are pleased with your high quality test stand with its big
functional range. If you have any queries, wishes or helpful
suggestions, do not hesitate to call our service number.
1. Included in delivery
- SAUTER TVM
- Various hooks
2. Drawings and dimensions (in mm)
3. Warning
Intended use
The instrument you have acquired serves to determine the
measuring value of the material to be measured. It is
intended to be used as a “non-automatic“ instrument, i.e.
the material to be measured is manually and carefully
attached at the instrument. The measuring value can be
read off after a stable measuring value has been obtained.
Be careful about the limit load of test stand and force
gauge. Do not go over the maximum force.
4. Technical Specifications
Capacity : 5000 Newton
Maximum Travel (Y):
214 mm
Max Speed: 0 to 240 mm / min
Rate flow 3 A
Fuse of main Circuit 3 A
Fuse of control Circuit 0,5 A
Work temperature 10 bis 30 °C
5. Operation
Turn on the power switch
Adjust the upper and lower limited position block to
suitable position
Choose between „Spot Motion“ (Manual) und „Continoues
Motion“ (Automatic)
Choose perfect measuring speed with „Speed dial“.
6. Attachment of grip or clamp
Mentioned below, a picture of the round base plate.
Fixture with four 4xM 6 or/and 1x M10 screws
Starting in 2012: borehole in the middle with M 12 thread