KERN & SOHN FT 1K - Manual (Page 3)

Instruction Manual
FT 1K
FT_SO-BA-e-1111 3
SAUTER GmbH
Tieringerstr. 11-15, D-72336 Balingen
Tel: +49 (0) 7433 9976 174
[email protected]
www.sauter.eu
5. Zeroing & Measure 8. Backlight
Keep pressing for about 2 seconds
Zeroing of display
Turning off automatically after approx. 15 Sek.
The tension and compression measuring function is
executed automatically. Compression measuring showes
„ – „ in front of measured result.
9. RS 232 PC Serial Interface
The instrument features an RS232 output via 3.5 mm
terminal. The connector output is a 16 digit data stream
which can be utilized to the user´s specific application. An
RS232 lead with the following connection will be required
to link the instrument with the PC serial input.
6. Normal Measurement
Slide Power Switch onto „I“
Choose unit and slide switch onto wanted unit
16-digit-Signal:
Put choosen attachment on
Zero adjusting by pushing Zero Button before all
measurments
Activate display reverse if needed
Changes from FAST to SLOW:
- FAST: about 0,2 Sek.
- SLOW: about 0,6 Sek.
In case of overload display is showing „-----„
7. Peak-Hold Measurement
Power-Switch onto „Peak-H.“
Same as „Normale Measurement“