Assembling the puffin swift – KERO Puffin Swift User Manual
Page 3
– 3 –
1.
Roll out the boat skin and assemble all the
rods.
2.
Insert both gunwales as far as they will go.
Close the black flaps to cover the ends.
3.
Assemble keel and stems.
4.
Position keel and stems inside the boat skin.
5.
Clip tube stubs at end of boat skin onto the
plastic fittings on top of the stems.
6.
Mount cross rib (C) at the angle point of the
keel.
7.
Mount cross ribs (A), (B1) and (B2).
8.
Mount the three remaining crossribs, (C)
and (D).
➜ The sections of the long rods are
internally connected by elastic cords to
ensure correct assembly.
Assembling the Puffin Swift
➜ The rear part of the kayak will be where
rib (B1) is installed.
➜ To install rib C the keel angle is moved to
the center of the kayak.
➜ As the cross ribs are installed the keel
will gradually straighten.
NOTE: The hull is symmetrical. It does not
matter at which end cross ribs (B1) and (B2)
are installed.
➜ The cross ribs are connected to the keel
by means of latch clips. Each cross rib has a
plastic clip at the center. Position this clip on
the keel as shown in Figure 3 and press in
the direction of the arrow until the latch clip
locks. Mount the elastic band to secure the
locking.
➜ The ends of the cross ribs clip to the
gunwales at openings in the gunwale
channels.
➜ The keel will now be at an angle.
➜ The curved pieces with plastic fittings are
stems. The narrow end of the stems fit into
the keel.
➜ The two longest rods are gunwales. They
are to be inserted in channels along the
edges of the boat skin. The channel
openings are under black flaps at one end of
the skin.
NOTE!
We recommend that you study this manual carefully before you start the assembly
procedure! When assembling the Puffin Swift, please refer to Figure 1 and Figure 2
of this manual.
Figure 3, Latch Clip
Keel
Cross Rib
Elastic
Band
Latch
Clip
➜ Make sure the keel is straight and the stems
are centered in the ends of the boat skin.
NOTE: Cross ribs lock to the gunwales when
the “wing” on the connecting clip is aligned
with the gunwales.