KERO Neris ALU 2 - Manual (Page 8)

Step . 6
Install the washboards. Before
installing the washboards replace the
wing nuts from U-bolts on Cross Ribs.
Insert the round rope skin edge into the
open end of the grooved channel at the
bottom of the washboard sections.
Engage curved bow section of the
washboard from the bow and rear
section from the stern according to
number marks.
Meet the washboard
holes with the U-bolts of Cross Ribs.
Secure the washboard sections by wing
nuts.
Make sure the first and last
washboard holes are secured first.
Then proceed with other sections.
Two people are recommended to
complete this step.
The first person
pulls the washboard in place. The other
person puts the wing nut on. When all
wing nuts are in place tight them up
securely.
7