Kuzma STOGI REF 313 VTA 91119 - Manual (Page 8)

8
9. Cueing device adjustment
Should you find that in the ‘up’ position the cartridge is too high or too low above the record
then the cueing device can be raised or lowered. This can be done simply by using Allen key
1.5 mm:
Insert key into screw on side of arm rest.
Release screw, raise or lower device and retighten.
Rotation of cueing device can affect the drift of cartridge while travelling vertically down.
The cueing device may lift slightly as the screw is retightened. Do not over-tighten as this
may cause the cueing device to stick in the ‘up’ position. Should this occur, slightly release
the screw. (Fig.1)
10. Maintenance
The bearing does not need maintenance. Clean dust from the tonearm with a soft cloth.
11. Transport
During transport the tube should be locked in the armrest and counterweight removed.
12. Problems
1. Cartridge jumps in the inner grooves: See if the tube can travel towards the centre of the
record- check that position of the tonearm is correct with protractor for distance.
2. Cartridge is too close to the record edge: Check if the tube travels too much toward the
centre of the record- check that position of the tonearm is correct with protractor for distance.
3. Headshell cannot be removed- check that the screw is released enough with Allen key.
Kuzma Ltd
Hotemaze 17A
SI-4205 PREDDVOR
SLOVENIJA
P: +386 4 25 35 450
F: +386 4 25 35 454
E mail:[email protected]
www.kuzma.si