Kuzma Stabi M 130105 - Manual (Page 7)

Note: Be careful when positioning the platter onto the subplatter if the armboard is already
mounted on the top chassis. There is only a small gap.
Platter:
Position the platter on the subplatter, holding the platter with both hands at the sides. Due to
the small gap between the lower edge of the platter and the top of the subchassis, do not hold
the platter underneath. Hold it firmly, so it will not slip. Be careful if the armboard is already
mounted because there is a small gap between the platter edge and the armboard corner.
Setting up the turntable
Front panel & top plate knob height adjustment
Mounting armboard and tonearm:
Note: The top chassis will reach its correct height position only when the weight of the platter
is added.
Suspension adjustment:
Height adjustment of the top plate is by rotation of the black knobs on the top. Turning the
adjustment knobs anticlockwise causes the top plate to rise. If you look at the edges of the top
of the plate and turntable outer frame they should be horizontally aligned. Adjust the height of
the top plate by turning the four knobs so that the top edge of the top plate is level with the
top of the turntable frame.
The best way to do this is to adjust two opposing knobs a little, then another two knobs a little
and the first pair again, etc. At this stage do not be too precise as the armboard and tonearm
have yet to be added and they will lower the top plate height.
7