Kuzma Stogi Reference - Manual (Page 10)

_________________________________________________________________
STOGI/STOGI REFERENCE 10 KUZMA
D. Height (VTA) Adjustment
(Fig. 14)
1. Put record on platter.
2. Remove tube from armrest with cueing device still in ‘up’ position.
3. Put stylus guard on.
4. Position needle in normal playing position above record with lift still up, to ascertain how
low or high the arm is.
5. If tonearm is too low, then the tonearm must be raised by releasing the screw in the base
while holding the tonearm by the ‘C’ shape and lifting up. (Fig. 15)
6.Tighten screw when tonearm is in position though do not overtighten.
7. Repeat process until arm is high enough to clear record.
8. Remove stylus guard and put cueing device in play position (down). The needle should be
in the groove. If not the tonearm is too high and should be lowered.
NOTE:To ensure needle is properly in the groove observe headshell, cartridge body
and (in standard Stogi) the tube, all of which should be parallel to the
surface of the record. This is more easily seen if the stylus is in
the middle grooves of the record side. (Fig. 14)