Operation introduction, Attention, Inspection – LABEC M-HOG-020D User Manual
Page 4
2
Ⅲ
Ⅲ
Ⅲ
Ⅲ、
、
、
、
OPERATION INTRODUCTION
1. Put container on stand base and keep distance between the head and bottom of container.
2. Turn the speed button to the end of left side.
3. Put plug into socket and then switch to be “ON” to start it.
4. Adjust speed button to be proper speed per your demand.
5. When you stop it, please turn speed button to the end of left side.
6. Switch the key to be “ OFF ”.
Ⅳ
Ⅳ
Ⅳ
Ⅳ、
、
、
、
ATTENTION
1. Do not start it without any material inside container.
2. The speed has to match material’s viscosity to avoid head at empty rotation.
3. Bad fluid is not suitable to the instrument
4. Heads are changeable, please loose the holding screw and take head off.
5. After you clean or change head, please must fix and screw it tightly.
ⅤⅤⅤⅤ、
、
、
、
INSPECTION
When the machine is out of order, please check following possible facts:
1. Fuse burns out or not
。
2. Carbon brushes at both sides of motor use out or contact improperly.
3. If carbon brushes use out, then take it off and renew it.
If above have been checked and useless, please send the machine back to agent for
further examination and maintenance.