Leitz Diamaster WhisperCut - Manual (Page 9)

Deuts
ch
Engli
sh
中
文
Ita
lia
no
Fr
ançaise
Espa
ñol
Po
rt
uguê
s
Ру
сс
кий
9 04/2012 ID.524571 V2.0
The tool has to be mounted, locked and started up on the machine as per the instructions
of the machine manufacturer.
Starting the machine during the tool change is not allowed (see handling instructions of
the machine).
Wear safety gloves!
Danger of injury by sharp cutting edges!
Before using the tool check the cutting parts, clamping screws and clamping elements for
correct and tight seating.
Danger of injuring from parts flying off.
The limits for the tool weight, -diameter and projection length recommended by the
machine manufacturer have to been observed.
Check the machine data, especially RPM and direction of rotation!
Danger of loosening of the tool.
Unproper stopping of the tool, e.g. by lateral pressing, is not allowed.
During mounting take care, that tool and all cutting and spare parts are mounted on
correct clamping devices.
When using stacked tooling ensure that the cutting parts are not in contact with each
other.
All clamping surfaces have to be free of dirt, grease, oil or water.
Cutting parts shall not come in contact with clamping elements or machine parts.
Tighten clamping screws and nuts by using appropriate mounting tool and the
recommended torque.
The extension of wrenches or the use of hammer blows is not permitted!
1.4.4 Precautions
Check the cutting edges, clamping elements, screws and tool bodies regularly for
potential damages – especially after collision of the tool with parts of the machine e.g.
machine table, work piece clamping elements, dust hood.
Damaged or worn cutting parts, clamping elements or screws have to be set-wise
immediately replaced with original replacement parts.