Lippert Components FT-CG07 & FT-CG07S - Manual

Frame Mount
Camper Tiedown System
IMPORTANT: READ THESE INSTRUCTIONS COMPLETELY BEFORE BEGINNING:
These Instructions will show installation of one side only. Both sides install the same except where noted otherwise.
STEP 1 – [Hardware Kit A] Attach both backing (guide) plates to stabilizer bar. Using
#10 x ¾” sheet metal screws. See diagrams below for specific location.
Note: The 4 large round holes in guide plate must be to the outer ends of the assembly
at both ends.
STEP 2 – [Hardware Kit C] Attach frame brace to guide plate by inserting the flat head,
square shouldered plow bolts through the countersunk hole in frame brace and securing
with flat washer, split lock washer and nut. See diagrams below for specific locations.
Note: Do not tighten the nuts at this time. They will be tightened at a later step.
Center Slots
FRONT ANCHOR INSTALLATION
1
REAR ANCHOR INSTALLATION
Rear anchors are installed in the end of the bumper. There is no precise mounting location
since a variety of bumpers may be installed.
IMPORTANT NOTE: If the stock GM bumper is installed on this truck,
The FM-CBB07 bumper brace kit MUST BE INSTALLED.
Installation is simple, requires no drilling and takes about 5 minutes.
Instructions are included with the bumper brake kit.
1. Mounting location should be as flat & vertical as possible.
2. Be sure no moldings or bumper caps interfere with the removable coupler.
3. Check back side of selected mounting location to ensure adequate
access for tightening nut.
4. Choose a location as far back as possible from the front edge of bumper
while giving consideration to the other criteria listed above and center
punch and drill a
1 / 8 ” pilot hole, then enlarge to 1 / 2 ”.
Install Anchor Bolt with 2” fender washer, lock washer & nut.
Flat edges of Anchor Bolt must be horizontal.
Remove
coupler
when not
in use to
prevent loss.
Flats Horizontal
Place well back
From front edge
Of bumper
4
505 N. Kays Drive, Kaysville UT 84037
Phone: (801) 544-2585
Fax: (801) 546-5241
Email: [email protected]
Web Address: www.happijac.com
All defective material must be returned to the factory via prepaid shipment. Upon inspection and determination of claims
warranted, the factory will repair/replace the material at no charge and return the repaired/replaced material to the
customer with delivery charges prepaid by Happijac via common carrier of Happijac's choosing. Upgrades and changes
to shipping mode resulting in additional shipping costs shall be at customers expense.
WARRANTY CLAIMS:
All products manufactured by Happijac Co. are warranted to the retail customer for one year from date of purchase
against defects in material or workmanship. Any defective part(s) will be repaired or replaced (at Happijac’s option)
without charge, when returned transportation prepaid.
There are no other expressed warranties except as set forth above and any implied warranties are limited in duration to
that of the expressed warranty. This warranty does not cover any damage due to misuse, negligence, or accidents. There
is no warranty covering consequential damages, incidental damages, or incidental expenses including damage to
property.
This warranty gives you specific legal rights. You may have other rights which may vary from state to state.
WARRANTY INFORMATION
TERMS OF THE WARRANTY:
Models: FT-CG07 & FT-CG07S
ALSO REQUIRED: USB-010 Stabilizer Bar & FM-CBB07 Bumper Brace
CAUTION While the FT-CG07 can be installed on any ’07 or newer Chevrolet/GMC
WARNING (New body style) truck model, the FT-CG07S CANNOT be installed on
an extended cab with the rear swinging door.
DOING SO WILL RESULT IN DAMAGE TO THE DOOR