Lippert Components CBB07 Bumper Brace Installaion - Manual

The frame brace runs between the bottom edge of the bumper and the bed
cross member near the rear tire. The connection to the bumper is made by
sandwiching the bumper between the large angular plate and the end of the
frame brace rod. The connection at the upper end of the rod is made by
connecting to an existing hole in the bed cross member.
(Drivers side installation shown)
Step 1. Assemble a right and left assembly
by placing a
3 /8” x 1 ½” bolt through the
frame brace rod at the end with the ¼” thick
reinforcing block, then through the angular
support plate. Install flat washer, split lock
washer and nut, leaving a gap for the bumper .
See fig. A
The passenger side setup is the
same except the large angular
place protrudes from the opposite
side of the frame brace.
Step2. Slip the bumper
between the small plate on the
frame brace rod and the larger
angular large plate, with the
angular plate turned out toward
the end of the bumper.
Dashed line in Fig B. shows the
plate location above the bottom
edge of the bumper. See fig. B
The other end of the frame brace
is attached to the bed cross
member beneath the bed of the
truck. Continue to step 3 for
installation detail for this end of
the brace.
INSTRUCTIONS CONTINUED
ON REVERSE
A Division of Lippert Components
CBB07
Chev / GMC
Bumper Brace
Installation Instructions
Fig. A
(Driver Side)
Bumper edge
between here.
Set frame
brace 1”
away from
outer bed
panel.
Underside of bumper
Fig. B
Block turned outward
under bumper.
1 ½” Bolt &
Flat Washer
Hex Nut &
Lock Washer
R
o
d
Plate
1”
BED CROSS
MEMBER
1030